Ikegami HC-HD300 Operation Manual page 89

1
Select "1" or "2" from MENU (1/4) "VF DISPLAY" - "DISPLAY MODE."
Characters appear in the viewfinder.
Reference:
Refer to "5.2 Settings from the Menu [Menu Configuration and content]" (P81) for how to display characters in the
viewfinder.
2
Set the SHUTT/SUP-V switch on the right side of the camera to SET.
One of the following modes is displayed:
- Preset shutter speed
- Variable shutter speed
- SUPER-V
Note:
Each time the SHUTT/SUP-V switch is pressed to the SET position, the mode switches are in the order of preset shutter,
variable shutter and SUPER-V.
3
Select "PRESET SHUTTER SPEED" or "VARIABLE SHUTTER SPEED."
4
While the characters are flashing in the viewfinder, turn the rotary pulse switch to the appropriate shutter speed
and press the SET button.
The value will be confirmed.
Note:
- The flashing stops automatically in approximately 3 seconds after the setting operation ends.
- When the characters are not flashing in the viewfinder, press the SET button. The characters will start flashing and the
shutter speed setting will be enabled.
- There are three ways to confirm the shutter speed:
- Press the SET button.
- Wait until the flashing stops.
- Set the SHUTT/SUP-V switch to OFF. The displayed speed is maintained until the switch is set to ON. The shutter speed is
validated when the switch is set to ON.
■ To cancel the Shutter Speed
1
Set the SHUTT/SUP-V switch to OFF.
5.1 Settings Using Switches on the Camera
HC-HD300 1412 VER1 (U)
5
73