Ikegami HC-HD300 Operation Manual page 77

2
Make sure that the ALARM indicator on the OCP or MCP is not flashing
When the camera self-diagnosis function detects errors, the ALARM indicator flashes, and the self-diagnosis information
will be displayed for 20 seconds.
OCP
Note:
You can display the self-diagnosis information and check the status on the PM attached to the base station by pressing the PM IND/
PAGE button even when the ALARM indicator is not flashing. If an OCP-10 is used, make sure you assign a function to an F switch
for this function..
■ To Control Power ON/OFF from OCP
It is possible to use the OCP to control the camera power switching.
When the CAM POWER switch of OCP has been turned ON/OFF, only the camera power is turned ON/OFF. The BS power is not
turned ON/OFF.
MCP
PM IND/PAGE
button
ALARM indicator
HC-HD300 1412 VER1 (U)
4.3 Turning ON Power
61
4