Switch Position Check - Ikegami HC-HD300 Operation Manual

4.2

Switch Position Check

4.2 Switch Position Check
When the camera is used for the first time, set the switches on the camera to the positions indicated in the figure below, and ensure
that the camera works properly. After ensuring that it works properly, set the switches according to the environment in which the
camera is used and shooting conditions.
■ Camera Right
- GAIN SELECT switch
- AWB SELECT switch
- CC FILTER switch (ECC) : A (3200K)
- ND FILTER switch
- OUTPUT SELECT switch : CAM
- SHUTT/SUP-V switch
Note:
When the camera is connected to the BS, the switches on the camera are disabled except the CC FILTER switch (ECC) and ND
FILTER switch. When the camera has operational priority for the CC FILTER (ECC) and ND FILTER switches, the FILTER local
indicator lights. Pressing the FILTER HEAD switch will switch the operational priority between the camera and the BS.
■ Camera Front
- P.FUNC switch : OFF
Note:
When the camera is connected to the BS, you cannot use the
P.FUNC switch.
■ Camera Rear
- INCOM FRONT VR SELECT switch : OFF
- ENG MIC switch
- PROD MIC switch
- MIC-1 POWER switch, MIC-2 POWER switch
Depending on the type of microphone to use, the power supply
settings differ.
Switch Position
AB+12V Supplies +12V AB power to the microphone.
OFF Supplies no power to the microphone.
Applicable for a dynamic microphone or
a microphone with built-in battery which
requires no power supply.
+48V Supplies +48V Phantom power
Reference:
For details on the microphone, refer to the instructions accompanying the microphone to be used.
58
: 0
: A
: 1 (100%)
: OFF
: ON
: ON
Description
HC-HD300 1412 VER1 (U)
SHUTT/SUP-V switch
GAIN SELECT switch
OUTPUT SELECT switch
AWB SELECT switch
P.FUNC switch
ENG MIC
switch
MIC-1
POWER
switch
CC FILTER switch (ECC)
ND FILTER switch
INCOM FRONT VR
SELECT switch
PROD MIC
switch
MIC-2 POWER
switch