Output Signal Check; Color-Bar Signal Check - Ikegami HC-HD300 Operation Manual

4.5 Output Signal Check

After turning ON the power, ensure that signals are correctly output on the PM and WFM. If the signals are not output for some
reason, check the following before concluding that there is a failure.
- Are the cables properly connected?
- Are the switches correctly set?
- Is the breaker thrown?
- Is the POWER switch set to ON?
Reference:
Refer to "3. INSTALLATION and CONNECTION" (P31) for connection of peripheral equipment.

Color-Bar Signal Check

1
Set the BARS button on the OCP or MCP to ON.
Ensure that a normal color-bar signal is output.
To output color-bar signals to the monitor system, operate the MONITOR SELECT button.
Note:
If an OCP-10 is used, make sure you assign the BARS function to an F switch for this check.
OCP
Note:
When no color is displayed on the SDTV signal while you use MCP-170 and press the "Y" button of the MONITOR SELECT buttons,
refer to the operation manual for MCP-170.
MCP
HC-HD300 1412 VER1 (U)
4.5 Output Signal Check
[SDTV]
BARS button
"ON"
100%
80%
60%
40%
20%
0%
MONITOR
-20%
SELECT button
"Y"
[HDTV]
100%
80%
60%
40%
20%
0%
-20%
4
PM
WFM
PM
WFM
63