Ikegami HC-HD300 Operation Manual page 104

5.2 Settings from the Menu
Menu Item
― SMOOTH KNEE
DTL V FILTER
PRESET FILE LOAD
― FILE SELECT
LOAD START
*3 : When compiling ABB/AWB reference files from the menu, No. 2 of S3 of the MPU module must be turned ON.
When changing the switch, be sure to first turn the power OFF.
After compiling the reference file, be sure to return No. 2 of S3 to OFF.
When compiling the reference file from the control panel, it is not necessary to turn this switch ON.
88
Initial
Setting Value
Setting
TYPE1, TYPE2, TYPE3,
TYPE-1
OFF
OFF ON, OFF
ENGINEER ENGINEER, FACTORY
READY, START,
READY
CANCEL
HC-HD300 1412 VER1 (U)
Description, Remarks
SMOOTH KNEE is a function to adjust the compression
level of the brightness signal with KNEE. It can be selected
from the following three setting types.
TYPE1 : The compression rate of brightness is low.
TYPE2 : The compression rate of brightness is medium.
TYPE3 : The compression rate of brightness is high.
If the V filter of the DTL is ON, the resolution in direction V
diminishes, making it possible to obtain an image with less
noise.
Function to load the user settings (ENGINEER SET FILE)
or factory settings (FACTORY SET FILE) for the level
adjustment or menu of the camera.
Used to return the camera state back to the previous or initial
settings.
ENGINEER : Initializes the state back to the user setting.
FACTORY : Initializes the state back to the initial factory
setting.
Executes initialization.
MENU DATA
ALL VF
× ×
○ ×
× ×
- -