Ikegami HC-HD300 Operation Manual page 109

■ ENGINEER (2/2)
Menu Item
PROCESS ENABLE
― COLOR CORR
― CUSTOM COL1
― CUSTOM COL2
PROGRAM UPDATE
VF CONT
RETURN ON CONT
HD SDI TRUNK SETTING
EMB .AUDIO OUT
HD SDI OUT
COLOR FILTER
OPTICAL ABERRATION CORR.
― CORRECTION
― CORR. LEVEL
OAC GUIDE MARK
VIDEO MAINTENANCE MODE
Q-TV MODE(50Hz)
PROGRAM UPDATE
FILE SELECT
Initial
Setting Value
Setting
ENABLE ENABLE, DISABLE
ENABLE ENABLE, DISABLE
ENABLE ENABLE, DISABLE
ENABLE ENABLE, DISABLE
ON ON, OFF
--- --- (ON, OFF)
LPF4 LPF1, LPF2, LPF3, LPF4
ENABLE ENABLE, DISABLE
0 -10 to 10
ON ON, OFF
6MHz x 2ch,
9MHz x 1ch 4.5MHz x 2ch,
9MHz x 1ch
---
HC-HD300 1412 VER1 (U)
5.2 Settings from the Menu
Description, Remarks
ENABLE : Enables control from the panel.
DISABLE : Disables control from the panel (Also disables
ON/OFF of processing and analog control.)
ENABLE : Enables ROM update from the panel.
DISABLE : Disables ROM update from the panel.
Sets whether the RETURN control signal is sent to VF or
not. Zoom operation is not effective when RETURN is ON.
Sets the addition of EMB signal to HD-SDI TRUNK
signal. However, this can be selected only when FA-97A is
connected.
Sets the frequency band of color difference signal (P b, P r)
for HD SDI signal.
The LPF1 is narrow band, and LPF2 and LPF3 are wider
bands in the respective order. LPF 4 (standard value) is the
widest band.
Switches Enable/Disable of aberration correction.
This setting is also saved when the power is turned off.
Therefore, set it to DISABLE if aberration correction is not
used.
Controls the level of correction.
Sets whether a reminder to be shown on the VF or not when
the aberration correction value is not properly received from
the serial lens.
Sets the Q-TV transmission mode when the operation
frequency is 50 Hz. Fixed to 1 ch when the operation
frequency is 59.94 Hz.
Updates all programs. (SOFT & DPROC FPGA & DRIVE
POLSE FPGA)
* The package VERSION is updated by this update.
MENU DATA
ALL VF
○ ×
○ ×
○ ×
○ ×
○ ×
○ ×
○ ×
5
○ ×
○ ×
○ ×
○ ×
- -
93