Function - Canon imageRUNNERC1022 Service Manual

Chapter 18
Sub item
OUTPUT SRVC-DAT
SYS-DAT
SYS-DMP
CNTR
ERR-LOG
SPEC
ERDS-COM
SRVC-LBL
<SENS-ADJ>
Not used
<SYSTEM>
Sub item
DOWNLOAD Switching to the download mode
<HV-TR>
Not used
<CCD>
Sub item
DF-WLVL1 Not used
DF-WLVL2 Not used
<PARAM>
Sub item
SYS-SW
SW Bit
05 7 Switching of whether or not to prohibit exporting of PWD in the address book (0: Do not prohibit
exporting, 1: Prohibit exporting)
Sub item
SYS-NUM
FAX-SW
FAX-NUM
NET-SW
NETNUM
NET-CERT VERSION
SRLNUM
SIGALG
ISSUER
VLD_FROM
VLD_TO
SUBJECT
PUB_KEY
THMB_PRT
CDC-SW
CDC-NUM
EXC-NAVI
18-24
COPIER > FUNCTION > MISC-P
Output of the system data list/system dump list
Output of the system data list
Mainly output the report of each service software switch and parameter used for FAX function.
Output of the system dump list
Output the service data such as the number of communication, number of received sheets, number of sent sheets, number of recording
sheets, and number of errors, etc.
Output of the counter report
Display the counter indicating how often the function of reading, recording, communication, and copy operation is performed.
Output of error logs
Output of the spec report
Print the current equipment condition.
Output of e-RDS communication error logs
Not used
COPIER > FUNCTION > SYSTEM
COPIER > FUNCTION > CCD
COPIER > FUNCTION > PARAM
Registration of system parameters (See the table shown below.)
COPIER > FUNCTION > PARAM
001 to 100
Not used
Not used
SW01 to SW50
001 to 050
CA certificate version
Serial number
Signature algorithm
Issuer
Commencement date of the expiration period
Finishing date of the expiration period
Subject of issuance
Public key algorithm and size
Digest (Thumb imprint)
Not used
Not used
Switch for whether or not to start up the installation navigation
When setting this switch to 1 after the installation navigation is completed, the installation navigation does not start up at the time
of next activation.
Setting value: 0: Start up the navigation. 1: Do not start up the navigation.
[Factory setting value/Value after RAM clearing: 0]
Description
T-18-23
Description
T-18-24
Description
T-18-25
Description
T-18-26
PARAM > SYS-SW

Function

T-18-27
Description
Remarks
Initial value: 1