Canon imageRUNNERC1022 Service Manual page 338

Chapter 12
CAUTION:
Do not change the setting values of URL (RGW-ADR) and port number (RGW-PORT) of UGW unless specifically instructed.
Changing the values results in an error in communication with UGW.
7. Select [COM-TEST] and then press [OK] button.
NOTE:
This initiates the communication test between the device and the UGW.
If the communication is successful, "OK" is displayed. If "NG" (failed) appears, refer to the "Troubleshooting" and repeat until "OK" is displayed.
NOTE:
The communication results with UGW can be distinguished by referring to the COM-LOG. By performing the communication test with UGW, E-RDS acquires
schedule information and starts monitoring and meter reads operation.
12-24
F-12-57