Canon imageRUNNERC1022 Service Manual page 337

Steps to E-RDS settings
1. Start [Service Mode].
1) Press [Main Menu] button on the control panel.
2) Press [2] button on the control panel.
3) Press [8] button on the control panel.
4) Press [Main Menu] button on the control panel.
2. Select [COPIER] > [Function] > [CLEAR] > [ERDS-DAT] and press [OK] button.
NOTE:
This operation initializes the E-RDS settings to factory setting values.
For the setting values to be initialized, see the section of "Initializing E-RDS settings".
3. Install or delete the CA certificate as required, and restart the device.
- Installation of CA certificate: Install it from RemoteUI.
- Deletion of CA certificate: The CA certificate installed at the time of shipment is automatically installed by going through the following steps.
CAUTION:
After following procedure, the registered key and CA certificate are deleted, and only the CA certificate installed at the time of shipment is registered.
It is therefore necessary to check with the user in advance.
(1) Start service mode.
(2) Select [COPIER] > [Function] > [CLEAR] > [CA-KEY] and press [OK] button.
(3) Reboot the device.
CAUTION:
If a key and a CA certificate have been registered in order to use a function other than E-RDS, it is necessary to register again from RemoteUI.
4. Start service mode.
5. Select [COPIER] > [Function] > [INSTALL] > [E-RDS] and press [OK] button.
6. Enter [1] and press [OK] button.
NOTE:
This operation enables the communication function with UGW.
F-12-55
F-12-56
Chapter 12
12-23