Paprwidth Mismatch; Paper Size Not Detected; Insufficient Paper For Job - Canon iPF8400SE imagePROGRAF User Manual

PaprWidth Mismatch

(When you have attempted to print a test print sheet or
other printer status information.)
PaprWidth Mismatch
PaprWidth Mismatch
When Detect Mismatch in the Control Panel menu is
set to Pause or Hold Job, the width of the loaded roll
does not match the width specified in Fit Roll Paper
Width in the printer driver.

Paper size not detected.

Paper size not detected.
Paper has been loaded askew, or warped paper has been loaded.
Because the Platen is soiled with ink or other substances, the size of the clear film
cannot be detected.
614

Insufficient paper for job

Insufficient paper for job
The printer has received a print job longer than the amount of roll paper left when
ManageRemainRoll in the Control Panel menu is On.
Cause
Cause
Cause
Cause
Corrective Action
(See "Removing the Roll from the Printer.")
(See "Removing the Roll Holder from Rolls.")
2.
Replace the roll with a roll 10 inches wide or larger.
(See "Loading Rolls on the Roll Holder.")
(See "Loading Rolls in the Printer.")
The printer will resume printing.
Press ▲ or ▼ to select Stop Printing, and then press the OK button.
Corrective Action
Press ▲ or ▼ to select Print, and then press the OK button to resume
printing.
However, note that this error may cause paper jams and affect the printing
quality.
Press ▲ or ▼ to select Stop Printing, and then press the OK button.
Follow these steps to replace the roll to match the width specified in the
printer driver.
1.
Press ▲ or ▼ to select Change Paper, and then press the OK button.
(See "Removing the Roll from the Printer.")
(See "Removing the Roll Holder from Rolls.")
2. Replace with paper of the width configured in the printer driver.
(See "Loading Rolls on the Roll Holder.")
(See "Loading Rolls in the Printer.")
The printer now starts printing the print job.
Make sure the roll width selected in the dialog box displayed when you se-
lect Fit Roll Paper Width in the printer driver matches the width of the roll
loaded in the printer, and then try printing again.
Lift up the Release Lever and reload the
paper.
(See "Loading Rolls in the Print-
er.")
(See "Loading Sheets in the Print-
er.")
If this error recurs after you reload the roll,
remove the Roll Holder from the printer,
push the roll firmly in until it touches the
Roll Holder flange, and reload the Roll
Holder in the printer.
(See "Loading Rolls on the Roll Hold-
er.")
Open the Top Cover and clean the entire
Platen.
(See "Cleaning Inside the Top Cov-
er.")
Press ▲ or ▼ to select Print, and then press
the OK button to resume printing.
iPF8400SE
P.345
➔
P.347
➔
P.337
➔
P.339
➔
P.345
➔
P.347
➔
P.337
➔
P.339
➔
Corrective Action
P.339
➔
P.360
➔
P.337
➔
P.564
➔
Corrective Action
User's Guide