The Contrast Becomes Uneven During Printing - Canon iPF8400SE imagePROGRAF User Manual

The contrast becomes uneven during printing

3
4
5
6
7
8
9
10
11
6
Using the back of the Cleaning Brush, move the Switch to the side opposite ●, corresponding to the size of
the paper for printing.
In this case, note that you will move the switch in the opposite direction from the direction in step 4.
Note
7
Close the Top Cover.
The contrast becomes uneven during printing
The contrast becomes uneven during printing
The paper feed amount is out of adjustment.
The type of paper specified in the printer driv-
er does not match the type loaded in the
printer.
598
Number
The Switch only moves number 1 and the number
•
that matches the paper size. Set all of the switches
where the number does not match the paper size in
switches number 2 and higher to the ● side.
Cause
Adjust the feed amount.
Load paper of the same type as you have specified in the printer driver.
Make sure the same type of paper is specified in the printer driver as you have loa-
ded in the printer.
1.
2.
355.6 mm (14.00 in)
431.8 mm (17.00 in)
515.0 mm (JIS B2 or B3)
594.0 mm (ISO A1 or A2) or 609.6 mm (24.00 in)
841.0 mm (ISO A0 or A1)
914.4 mm (36.00 in)
1030.0 mm (JIS B0 or B1)
1066.8 mm (42.00 in)
1117.6 mm (44.00 in)
(See "Adjusting the Feed Amount.")
(See "Loading Rolls in the Printer.")
(See "Loading Sheets in the Printer.")
Press the Stop button and stop printing.
Change the type of paper in the printer driver and try printing again.
Dimensions
Corrective Action
P.526
➔
P.339
➔
P.360
➔
iPF8400SE
User's Guide