Canon iPF8400SE imagePROGRAF User Manual page 151

iPF8400SE
• B
Between Pages
You can set the time to wait after printing 1 document page until ejecting the paper. Since waiting time is re-
quired for ink to dry before a roll is cut, you can deliver paper in the Output Stacker with the ink dried even if
Cutting Mode is set to Automatic.
Setting Item
Printer Default
Off
30 sec. / 1 min. / 3 min. / 5 min. /
10 min. / 30 min. / 60 min.
• C
Between Scans
You can set the time to wait after printing 1 line on a page until printing the next line. Set this to avoid bleeding
or color unevenness such as when bleeding occurs on a page or when color unevenness occurs during bor-
derless printing.
Setting Item
Printer Default
Off
1 sec. / 3 sec. / 5 sec. / 7 sec. / 9
sec.
D
Roll Paper Margin for Safety
You can specify the length of a margin on the leading edge of paper to ensure that paper susceptible to curling is
held firmly against the Platen.
• E
Near End Margin
Specify the length of the Near End Margin (the leading edge margin) of the roll, as needed.
Setting Item
Printer Default
5 mm (0.2 in)
20 mm (0.8 in)
F
Cut Speed
Select the speed of automatic cutting, as needed. You can adjust this setting if paper is not cut well when automat-
ic cutting is used.
Setting Item
Printer Default
High Speed
Standard
Low Speed
G
Mirror
Specify whether to print a mirror image, as needed. Select this option to print a version of the document or image
with the left and right sides inverted.
User's Guide
The setting of the control panel of the printer is applied.
Paper is ejected immediately after printing completes.
Paper is ejected when the set time elapses after printing completes.
The setting of the control panel of the printer is applied.
The next line is printed immediately after a line is printed.
The next line is printed when the set time elapses after a line is printed.
* Increase the time according to the occurrence condition of bleeding or unevenness.
The setting of the control panel of the printer is applied.
The document is printed in the standard size.
* Select this when you do not have any problems in printing.
Select this when rubbing against the printhead occurs such as when using paper that
tends to curl.
The setting of the control panel of the printer is applied.
When the Standard setting does not result in cutting the surface cleanly, select this.
Select this when you do not have any problems in automatic cutting.
This helps prevent adhesive from sticking to the cutter and keeps the cutter sharp if you
select it when using adhesive paper.
Paper Detailed Settings Dialog Box
Details
Details
Details
Details
151