Canon iPF8400SE imagePROGRAF User Manual page 451

iPF8400SE
Mainte-
Change Cutter
nance
Inter- EOP Timer
face
Setup
TCP/IP IPv4
IPv6
Net- NetWare
Ware
Frame Type
Print Service
AppleTalk
Ether- Auto Detect
net
Driver
Comm.Mode
Ethernet Type
Spanning Tree
User's Guide
Setting Item
IPv4 Mode
Proto- DHCP
col
BOOTP
RARP
IPv4 IP Address
Settings
Subnet Mask
Default G/W
DNS DNS Dync update
Settings
Pri. DNS SrvAddr
Sec. DNS SrvAddr
DNS Host Name
DNS Domain Name
IPv6 Support
IPv6 StlessAddrs
DHCPv6
DNS DNS
Settings Dync
update
Pri. DNS SrvAddr
Sec. DNS SrvAddr
DNS Host Name
DNS Domain Name
Description, Instructions
Replace the Cutter Unit. Follow the instructions displayed
to complete the required procedure. (See "Replacing the
Cutter Unit.")
P.554
➔
Once you replace the Cutter Unit, you can also reset the
cut counter.
Specify the timeout period before cancellation of print jobs
that cannot be received by the printer.
Choose whether the printer IP address is configured auto-
matically or a static IP address is entered manually.
Specify the protocol used to configure the IP address au-
tomatically.
Specify the printer network information when using a stat-
ic IP address.
Enter the IP address assigned to the printer, as well as
the network subnet mask and default gateway.
The value that was automatically configured is displayed if
you have set IPv4 Mode to Automatic.
Specify whether DNS server registration is updated auto-
matically.
Specify the DNS server address.
Specify the DNS host name.
Specify the DNS domain name.
Specify whether to connect via IPv6.
Specify whether a IPv6 stateless address is used.
Specify whether DHCPv6 settings are used.
Statefull Specify whether DNS server registration is updated auto-
Addr matically.
State-
less
Addr
Specify the DNS server address.
Specify the DNS host name.
Specify the DNS domain name.
Specify the NetWare protocol. To apply your changes,
choose Register Setting.
Specify the frame type to use.
Choose the print service.
Specify whether to use the AppleTalk protocol. To apply
your changes, choose Register Setting.
Specify the communication method. To apply your
changes, choose Register Setting.
Choose On for automatic configuration of the LAN com-
munication protocol. Choose Off to use settings values of
Comm.Mode and Ethernet Type.
Choose the LAN communication method.
Choose the LAN transfer rate.
Choose whether spanning-tree packets are supported
over the LAN.
Menu Settings
451