Other Maintenance; Preparing To Transfer The Printer - Canon iPF8400SE imagePROGRAF User Manual

Preparing to Transfer the Printer

Other Maintenance

Other Maintenance
Preparing to Transfer the Printer ............................................................................................................................. 568
Reinstalling the Printer .................................................................................................................................................. 574
Updating the Firmware ................................................................................................................................................. 577
Preparing to Transfer the Printer
Preparing to Transfer the Printer
To protect the internal parts in transit, always follow these steps before transferring the printer to a new location.
Refer to the Setup Guide for details on packing the printer and installing it after transfer.
• Be sure to contact your Canon dealer before transferring the printer to a new location. Ink may leak and damage
the printer if you do not prepare the printer correctly and it is tipped or stood on end in transit.
Important
• Depending on the state of the printer, part replacement may be necessary when preparing to transfer the printer
(that is, when you execute the printer menu item to prepare for transfer).
Note
• Ink must be drawn into the Maintenance Cartridge before Level 2 or Level 3 printer transfer, as described in the
following table. Prepare the Maintenance Cartridge in advance.
• Always follow the instructions of the service representative when transferring the printer under Level 3 conditions.
Level
1
2
3
568
*1: This is the number of new Maintenance Cartridges required when you execute the Prep.MovePrinter menu.
*2: If a message instructing you to replace the Maintenance Cartridge is displayed on the Display Screen, the
Shipping Method (Exam-
ple)
By truck Lengthwise: 0–30º
Rotation: 0–10º
By plane All directions: 0–30º
Tipping the printer or Lengthwise: 0–90º
holding it upright for Rotation: 0–30º
elevators or stairs
The number varies depending on the amount remaining in the Maintenance Cartridge being used.
Maintenance Cartridge needs to be replaced.
Permitted Angle of Inclination
iPF8400SE
Required Main-
Amount of Ink to Dis-
tenance Car-
pose of
tridges( *1 )
0 0( *2 )
Approx. 350 ml 1 or 2
(11.8 fl oz)
Approx. 1,000 ml 1 or 2
(33.8 fl oz)
User's Guide