Cannot Print Over A Network; Cannot Connect The Printer To The Network; Cannot Print Over A Tcp/Ip Network; Cannot Print Over A Netware Network - Canon iPF8400SE imagePROGRAF User Manual

iPF8400SE

Cannot print over a network

Cannot print over a network

Cannot connect the printer to the network ......................................................................................................... 601

Cannot print over a TCP/IP network ....................................................................................................................... 601

Cannot print over a NetWare network ................................................................................................................... 601

Cannot print over AppleTalk or Bonjour networks ........................................................................................... 602
Cannot connect the printer to the network
Cannot connect the printer to the network
Cause
The Ethernet cable
1.
is not connected
correctly to the
2.
printer's Ethernet
port.
Cannot print over a TCP/IP network
Cannot print over a TCP/IP network
Cause
The printer's IP address is not configured
correctly.
The printer's TCP/IP network settings are
not configured correctly.
The computer you are trying to print from
is not configured correctly.
Cannot print over a NetWare network
Cannot print over a NetWare network
Cause
The printer's NetWare settings
are not configured correctly.
The computer you are trying to
print from is not configured cor-
rectly.
The NetWare server and serv-
ices are not configured correct-
ly.
User's Guide
Make sure the printer is connected to the network with the correct Ethernet cable, and then turn the printer
on. For instructions on connecting the cable, refer to the Setup Guide.
Make sure the Link indicator is lit.
The Link indicator is green if the printer is connected via 100 Base-TX and orange if connected via
10Base-T.
If the Link indicator is not lit, check the following points.
•
Make sure the hub is on.
• Make sure the end of the Ethernet cable is connected correctly.
Insert the Ethernet cable until it clicks and locks in place.
•
Make sure there is no problem with the Ethernet cable.
If there is any problem, replace the Ethernet cable.
• Check the communication mode with the hub.
Although the printer normally detects the hub communication mode and transmission rate automatical-
ly (in auto negotiation mode), sometimes the hub settings cannot be detected. In this case, configure
the connection method manually, specifying the communication mode in use.
(See "Configuring the Communication Mode Manually.")
Make sure the printer's IP address is configured correctly.
(See "Configuring the IP Address Using imagePROGRAF Device Setup Utility.")
(See "Configuring the IP Address Using the Printer Control Panel.")
Make sure the printer's TCP/IP network settings are configured correctly.
(See "Configuring the Printer's TCP/IP Network Settings With RemoteUI.")
Make sure the computer's TCP/IP network settings are configured correctly.
(See "Configuring the Printer Driver Destination (Windows).")
(See "Configuring the Destination in TCP/IP Networks (Mac OS).")
Make sure the printer's NetWare settings are configured correctly. In particular, make sure a valid
frame type is selected.
(See "Configuring the Printer's NetWare Network Settings With RemoteUI.")
Make sure the computer's NetWare settings are configured correctly.
(See "Configuring NetWare Network Settings.")
Check the following points.
1.
Make sure the NetWare file server is running.
2. Make sure there is enough free disk space on the NetWare file server. Insufficient disk space
may prevent you from processing large print jobs.
3.
Start NWADMIN or PCONSOLE and confirm that the print service is configured correctly and
the print queue is available.
Cannot connect the printer to the network
Corrective Action
P.496
➔
Corrective Action
Corrective Action
P.484
➔
P.498
➔
P.477
➔
P.481
➔
P.480
➔
P.492
➔
P.489
➔
601