Access Port Commands - HP 3000 9x9KS Service Manual

Access Port Commands

Access to the Access Port (AP) commands is via the ctrl + B function, with the SPU key switch in the
SERVICE position.
Command Description
CA Configure command for the Access Port Internal/external modem port, system identification, bit
CO Enter console mode
CS Copy screen from local to remote con-
sole terminal
DI Disconnect line to remote console termi-
nal
DR Disable access by a remote console ter-
minal
DS Disable display of system status line
ER Enable access by a remote console termi-
nal
ES Enable display of system status line
HE Display AP commands
LR Lock remote
MS Displays modem status
*
Reset system, initiates SPU selftest,
RS
stops processing
SE Transfers remote terminal from console/
control to session mode
SL Displays last 50 chassis codes
SO Sets the security level
TA Initiates ap selftest
* Transfer of control
TC
TE Sends message between the remote and
local consoles
UR Unlock remote
* These commands RESET the system. Be very careful using them, it could result in lost data and it
will crash all users on the system.
Table B-1. Access Port Commands
Remarks
rate, protocol, and:
3000 only - Allows autoanswer to be ON or OFF
9000 only - Allows selection of HP or Non-HP console
Enable session mode access
Disable session mode access
Disable modem access
Hit return to stop
Starts software load from load device if autoboot enabled.
Does not reset AP
Requires a PASSWORD (Call the Response Center for the
password).
Retains memory status
Enable modem access
CAUTION
Support Information B-6