HP 3000 9x9KS Service Manual page 39

Register Unit
S0 1 ring
S1 1 ring
S2 ASCII
S3 ASCII
S4 ASCII
S5 ASCII
S6 1 second
S7 1 second
S8 1 second
S9 100 mSec
S10 100 mSec
S11 1 mSec
S13 ASCII
S17 10 mSec
S24 50 mSec
S25 100 mSec
S26 1
S30 minutes
S32 100 mSec
S34 ASCII
Digit Words
0 OK
1 CONNECT
2 RING
3 NO CARRIER
4 EEROR
5 CONNECT 1200
6 NO DIAL TONE
7 BUSY
8 NO ANSWER
9 CONNECT 2400
11 CONNECT 4800
12 CONNECT 9600
13 CONNECT 14400
Table 2-6. S-Register Definitions
Range Description
0-255 Sets number of rings until modem answers.
0-255 Counts rings which have occurred.
0-127 Sets escape code character.
0-127 Sets character recognized as RETURN.
0-127 Sets character recognized as LINE FEED.
0-127 Sets character recognized as BACKSPACE.
2-255 Determines wait time for dial tone.
1-255 Determines how long modem will wait for carrier before aborting
the call.
0-255 2 sets pause time caused by a comma character in a dial command.
1-255 Sets carrier detect response time.
1-255 Sets delay time between when carrier is lost and when modem
disconnects.
1-255 Sets time duration of and spacing between tones in tone-dialing.
0-127 Determines remote configuration escape character.
0-2.5 Determines length of break time in seconds (space) to PC.
0-255 Sets DSR/CTS/CD dropout time.
0-255 Sets DTR dropout time.
0-255 Specifies allowed failed attempts.
0-255 Inactivity timer used to disconnect modem.
0-255 Set duration in which modem will wait for a <RETURN> to be
entered during escape sequence execution.
0-60 Buffer length of command mode after on-line escape sequence.
Table 2-7. Modem Result Codes
Effect
Command was executed without error, ready for next command.
Modem has detected carrier and gone on-line.
Modem has detected ring caused by incoming call.
No carrier signal has been detected within the allowed time.
Error in command line (too many, or invalid characters).
Modem has detected carrier at 1200 bps and gone on-line.
No dial tone has been detected.
A busy signal has been detected.
Remote system did not answer.
Modem has detected carrier at 2400 bps and gone on-line.
Modem has detected carrier at 4800 bps and gone on-line.
Modem has detected carrier at 9600 bps and gone on-line.
Modem has detected carrier at 14400 bps and gone on-line.
Install and Configuration 2-19