HP Cisco Catalyst Blade Switch 3020 Release Note

Release Notes for the Cisco Catalyst
Blade Switch 3020 for HP,
Cisco IOS Release 12.2(55)SE and Later
Revised March 28, 2012
Cisco IOS Release 12.2(55)SE runs on the Cisco Catalyst Blade Switch 3020 for HP, referred to as the
switch. If you wish to use Device Manager to upgrade the switch from Cisco IOS Release 12.2(35)SE
through Cisco IOS Release 12.2(40)SE1 (the LAN Base image) to Cisco IOS Release 12.2(50)SE or later
(the IP base image), you must first upgrade to Cisco IOS Release 12.2(40)SE2.
These release notes include important information about Cisco IOS Release 12.2(55)SE and any
limitations, restrictions, and caveats that apply to them. Verify that these release notes are correct for
your switch:
•
•
•
For the complete list of Cisco Catalyst Blade Switch 3020 for HP documentation, see the
Documentation" section on page
You can download the switch software from this site (registered Cisco.com users with a login password):
http://www.cisco.com/cisco/web/download/index.html
Contents
•
•
•
•
•
Americas Headquarters:
Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA
© 2012 Cisco Systems, Inc. All rights reserved.
If you are installing a new switch, see the Cisco IOS release label on the switch packaging.
If your switch is on, use the show version privileged EXEC command. See the
Software Version and Feature Set" section on page
If you are upgrading to a new release, see the software upgrade filename for the software version.
See the "Deciding Which Files to Use" section on page
"System Requirements" section on page 2
"Upgrading the Switch Software" section on page 3
"Installation Notes" section on page 6
"New Software Features" section on page 6
"Limitations and Restrictions" section on page 7
3.
34.
"Finding the
3.
"Related