Creating The Firmware Update Tape - HP 3000 9x9KS Service Manual

Creating The Firmware Update Tape

There are two parts to this section. They are:
1. Creating a firmware update tape using files from HPESC.
2. Creating a firmware update tape using the Support Media.
Creating a Firmware Update Tape Using Files From HPESC.
1. After retrieving the patch file from HPESC, you must unshar the patch file as follows:
prompt: sh PF_TPPPdddd
Two additional files will now be available. These files are TPPPdddd.text and TPPPdddd.frm. The
.text file provides specific instructions for that release of firmware. The TPPPdddd.frm file is the
actual update image file.
2. Verify the checksum of the TPPPddd.frm file using the "sum" command, as follows:
prompt: sum TPPPdddd.frm
Results of the command should be equal to the sum field that is documented in the header of the .text
file.
3. Use the "dd" command to copy the file "TPPPdddd.frm" to tape, as follows:
dd if=TPPPdddd.frm of=/dev/rmt/0m bs=2k
Creating a Firmware Update Tape Using The Support Media
Creating a firmware update tape using the Support Media is documented in the 10.01 version of the Support
Media Users Manual. (p/n 92543-90010)
B-17 Support Information
^^^^^^^^^^^
(device path dependent)
Note
Blocksize (bs) must be = 2k