HP 3000 9x9KS Service Manual page 25

Display Panel
SWITCH OFF
PROCEEDING TO
TURN DC ON
OSTAT XXXX
OSTAT XXXX
CPU XXXX
OSTAT XXXX
CPU XXXXX
RUN FXYF
CPU XXXXXX
OSTAT in the above sequence can equal one of the following states:
• OFF
• FLT (fault)
• TEST
• INIT (initialize)
• SHUT (shutdown)
• WARN (warning)
• RUN
• ALL
This sequence is followed by the system prompt. Refer to the System Administrators Manuals for the
appropriate operating system instructions to proceed with the system configuration.
Environment
Key switch in Standby.
No power cord.
Key switch in Standby.
Power cord installed.
Key switch is On.
Key switch is On.
PDC is loading.
Key switch is On.
ISL is running.
Key switch is On.
OS load in process.
Key switch is On.
OS load complete.
OS is running.
Observations
Blank Display.
AC power installed, back light is off. Front panel
displays SWITCH OFF
Display panel shows message, back light is on 1 to
2 seconds after display starts.
Ostats and chassis codes are displayed at the panel
and console banner. Chassis codes range from
0000 to CDFF. Refer to Chapter 4.
System initialization codes are being displayed.
OS or Diag loading can be started. Codes range
from CE00 to CEDF. Refer to Chapter 4.
OS is loading from disk or tape. Codes may range
from CEE0 to CFFF. Refer to Chapter 4. CPU
XXX shows processors installed (0-5).
The OS is finished loading. The X after RUN =
CPU utilization, The Y= number of processors.
CPU XXX shows processors installed (0-5).
Install and Configuration 2-5