HP 3000 9x9KS Service Manual page 97

Table 4-10. Memory Subsystem Codes (Continued)
Ostat Code
TEST C265
TEST C270
TEST C280
TEST C278
TEST C2A0
TEST C2B0
TEST C2E0
TEST C2C1
TEST C2C2
WARN 7800
FLT 7800
WARN 7801
WARN 7802
FLT 7803
FLT 7804
FLT 7D00
FLT 7D01
FLT 7D02
FLT 7D03
FLT 7D04
FLT 7D05
FLT 7D06
FLT 7D07
FLT 7D08
FLT 7D09
FLT 7D0A
FLT 7Fxy
Description
Testing memory, read test
RE-interleaving memory
Configure to EEPROM
Configure to EEPROM
*Flat configuration
*Flat ROM configuration
Memory testing done
Memory soft reset
Memory non destructive RAM test
PDT disabled warning
PDT disabled halt
Overwrite single bit error with multi-bit error in PDT
Duplicate PDT entry
EEPROM fault while updating PDT
PDT table is full
Memory fault
Icache parity error in memory test
Dcache parity error in memory test
MSI read time-out (HPMC, caused by accessing beyond the end of memory or
non-responding Slave Memory Controllers)
MSI write time-out (HPMC, caused by accessing beyond the end of memory or
non-responding Slave Memory Controllers)
Processor Memory bus parity fault (HPMC)
Write bomb fault (HPMC, earlier write transaction to memory had a bus parity
error)
Memory address fault (HPMC)
Multi-bit memory fault (HPMC)
Single bit memory fault (HPMC)
Address did not map to bank (HPMC)
x = memory carrier card number, y = SIMM pair slot number
Display Codes 4-13