HP 3000 9x9KS Service Manual page 96

Ostat Code
FLT 722x
FLT 7230
FLT 7301
FLT 7302
FLT 7303
FLT 7304
FLT 7305
FLT 7306
FLT 7307
FLT 7308
FLT 7401
FLT 7402
FLT 7403
FLT 7404
FLT 7405
FLT 7500
FLT 7501
FLT 7502
FLT 7604
FLT 7Fxy
WARN 7701
WARN 7702
WARN 7703
WARN 7704
WARN 7705
WARN 7706
WARN 770F
TEST C210
TEST C220
TEST C230
TEST C240
TEST C250
TEST C260
TEST C261
TEST C262
TEST C263
TEST C264
4-12 Display Codes
Table 4-10. Memory Subsystem Codes (Continued)
Description
Bad Slave Memory Controller revision, x = SMC 0-3 on memory carrier 0
Slave Memory Controller failed to respond
SIMM 0 bytes are not equal
SIMM 1 bytes are not equal
SIMM 0 data <> SIMM 1 data
Unknown sizing compare fault
Multi-bit error occurred during sizing
Address test failed on bank
ECC test failed on bank
Single bit memory error caused HPMC
No memory SIMMs installed
Both EDO and STD memory SIMMs installed
Address did not map to bank
Address did not map to Group Configuration Table
Dual issue test failed
No RAM found
Not enough good memory to run Operating System
Not enough good memory to run Boot Console Handler
No bits set in memory test status
x=SMC#, y=SIMM pair
Using alternate memory configuration
Memory not tested, initialized only
SIMM loading warning
RAM bus warning
Good memory required to run Operating System is greater than memory size
Both EDO and Standard DRAMs in system.
Rev 1 Slave Memory Controller installed
Memory hard reset
Physical configuring memory
Sizing memory banks
Loading memory configuration from EEPROM
Configuring memory interleave
Testing memory interleave
Testing first page of memory
Testing dual issue
Testing memory, write test
Testing memory, read/write test
x = SMC 4-7 on memory carrier 1