HP 3000 9x9KS Service Manual page 72

Step in procedure
At PDC interface, set autoboot flag to
ON. Power off the SPU and remove
all assemblies except the system
board.
Install power supply, power monitor
and display panel only.
Install CPU card in CPU slot 0.
Install memory carrier with NO
SIMMS
Install SIMM in slot 0a on memory
carrier
Install SIMM in slot 0b
Install core I/O card.
Install peripheral bay.
Shut down the OS. Reboot and inter-
rupt the boot process to stop at PDC.
Set the autoboot flag to OFF.
Power off the SPU and remove the
peripheral bay.
Reboot the system.
Type bo pri
Install the peripheral bay.
Type bo pri
3-28 Troubleshooting
Table 3-15. System Build-UP Procedure
Display/Console Results
Proceeding to turn DC on
FLT 7200
FLT 7500
FLT 7F00
FLT A088
WARN A008
(Operating system prompt)
INIT C440
WARN 80F5
Cannot find ENTRY_TEST
Failed to initialize
ENRTY_INIT
Status = -7
(PDC prompt)
(operating system prompt)
Meaning
At least one processor must be installed
for PDC to take control of the boot pro-
cess
No SMC available
No RAM available
Bad SIMM pair
No console found
No bootable device found
Boot complete
Initializing the stable storage console
path
Boot device failed
Boot complete