Top Cap, Sides, And Rear Bezels; Top Cap; Sides; Rear Bezels - HP 3000 9x9KS Service Manual

Top Cap, Sides, and Rear Bezels

The top cap, sides and rear bezels do not have to be removed in order to access any FRUs. The top
cap has to be removed before the sides can be removed. The rear bezels (one top and one bottom)
can be removed without removing the top cap or sides.

Top Cap

Removal:
1. Remove the front bezel.
2. Push the front edge of the top cap toward the rear of the cabinet. Be sure to secure the SPU while
pushing the top cap, or it may roll in the direction being pushed.
3. When the top cap snaps back, lift it straight up and away from the chassis.
Replacement:
1. Position the top cap over the chassis aligning the lock tabs over the key-lock slots in the top of the
chassis. Lower the top cap onto the chassis.
2. Push the top cap toward the front of the cabinet until; it snaps into place. Be sure to secure the SPU
while pushing the top cap, or it may roll in the direction being pushed.
3. Replace the front bezel.

Sides

Note that SPU sides are not reversible, this is due to the chassis angle on the right side of the cabinet.
Removal:
1. Remove the top cap.
2. Grasp the bottom of the side and pull straight up until alignment tabs clear the chassis slots.
3. Pull the side away from the chassis.
Replacement:
1. Position side next to chassis (parallel and slightly higher that top edge of chassis) with alignment tabs
over slots in chassis.
2. Push in and down to lock side into place.

Rear Bezels

The rear bezels snap onto the chassis.

Processor Card

The HP9000/Kx70 can have up to six (2 in the front and 4 in the back) processor cards installed. The HP
3000/959KS/969KS/979KS and HP 9000/K4x0 can have up to four (two in the front and two in the back)
Removal and Replacement 7-3