HP 3000 9x9KS Service Manual page 111

WARNING: The Core I/O board or system board has failed, resulting in
reduced I/O slot availability.
Use the IN IO command to verify .
WARNING: Not enough error-free contiguous memory (GoodMem).
the "ME " command in the INFORMATION menu and the
command in the SERVICE menu for error information.
Check the PDT and replace SIMMs as necessary
Memory page deallocation has been disabled because the Page
Deallocation Table (PDT) is full.
disabled, a memory error was detected after the table was full.
Refer to the
information.
Check the PDT and replace SIMMs as necessary.
WARNING: Memory has been initialized, but not tested as a result of
FASTBOOT being enabled.
command in the Configuration menu and reboot the system.
Disable FASTBOOT by the "Fastboot OFF" command in the CONFIGURATION menu and
reboot the system.
WARNING: Memory configuration is not optimized for performance.
to the System Installation or Memory Installation manuals for
memory configuration guidelines.
Re-sequence the memory SIMMs in accordance with the referenced guidelines (also contained in
Appendix C of this manual).
WARNING: An empty memory slot has been detected which should contain
a SIMM.
Re-sequence the memory SIMMs in accordance with the guidelines contained in Appendix C of
this manual.
WARNING: Memory has been reconfigured due to a physical change or
because the Page Deallocation Table (PDT) was cleared.
for information only.
Advisory message only.
WARNING: Memory has been deallocated due to a SIMM size mismatch or a SIMM
failure. Refer to the
for error information.
Verify that the SIMM pairs (0A/0B, 1A/1B, etc.) are of the same size.
WARNING: Memory is not configured for optimized performance due to
an improper distribution of memory module types across
extenders.
Re-sequence the memory SIMMs in accordance with the guidelines contained in Appendix C of
this manual.
WARNING: A Processor has failed selftest and has been deconfigured.
Refer to the
of deconfigured processors.
A processor failed the Floating Point Unit selftest. Replace the processor card.
"PDT " command in the SERVICE menu for error
To test memory, use the
BOOT COMMAND DISABLED.
No action is required.
"ME " command in the INFORMATION menu
"PR " command in the INFORMATION menu for a list
Refer to
"PDT "
If the Boot command is
"FASTBOOT "
Display Codes
Refer
This is
4-27