Table 12-4 Access Port Commands - HP 9000 Series Service Manual

Remote Management/Access Port Card
Access Port Commands
Entry to the Access Port (AP) commands is via the ctrl + B function, with the Service/Normal switch
in the Service position.

Table 12-4 Access Port Commands

Command
CA Configure command for the Access Port
CO Enter console mode
CS Copy screen from local to remote
console terminal
DI Disconnect line to remote console
terminal
DR Disable access by a remote console
terminal
DS Disable display of system status line
ER Enable access by a remote console
terminal
ES Enable display of system status line
HE Display AP commands
LR Lock remote
MS Displays modem status
RS* Reset system, initiates SPU selftest,
stops processing
SE Transfers remote terminal from
console/control to session mode
SL Displays last 50 chassis codes
SO Sets the security level
TA Initiates ap selftest
TC* Transfer of control
TE Sends message between the remote and
local consoles
UR Unlock remote
12-14
Description Remarks
Internal/external modem port, system
identification, bit rate, protocol, and
allows selection of HP or Non-HP
console
Enable session mode access
Disable session mode access
Disable modem access
Hit return to stop
Starts software load from load device if
autoboot enabled
Requires a PASSWORD (Call the
Response Center for the password).
Retains memory status
Enable modem access
Chapter 12