Hp 3000/939Ks/959Ks/969Ks/979Ks And Hp 9000/K2X0/K4X0/Kx70 Simm Replacement; Lcd Display - HP 3000 9x9KS Service Manual

6. Grasp the outside edges of the SIMM card and lift the SIMM out of the carrier connector.
HP 3000/939KS/959KS/969KS/979KS and HP 9000/K2x0/K4x0/Kx70 SIMM
Replacement
1. Align SIMM card over the appropriate carrier connector (white edge and part number toward the
extractor end of the connector).
2. Put the extractor lever in the up position.
3. Press the SIMM card firmly into the connector. Be sure the SIMM is fully seated into the carrier
connector.
4. Replace the carrier card from the slot (0 or 1) from which it was removed.
5. Insert the carrier card until contact with the system board is made, then push the extractor levers
down to fully seat the carrier card. The extractor levers should be flat against the carrier card edge.
6. Replace the front cover plate.
7. Replace the front bezel.

LCD Display

Removal:
1. Remove the front bezel.
2. Press the two mounting tabs on top of the display, while pulling the top of the display away from the
chassis.
3. Lift the display up and slightly away from the chassis.
4. Disconnect the interface cable from the back of the display assembly.
Replacement:
1. Attach the interface cable to back of the display.
2. Angle the bottom of the display to hook over the edge of the mounting hole in the chassis.
3. Push the top of the display toward the chassis, while pushing slightly down on the mounting tabs, until
the tabs snap into the chassis mounting slots.
4. Replace the front bezel.
Removal and Replacement 7-11