HP 3000 9x9KS Service Manual page 101

Table 4-15. MPE/iX B000 Halt Codes (Continued)
Code Description
0042 A bus converter was added on power fail
0043 Memory was added on power fail
0044 A module was added on power fail and generated an address conflict
0045 memory selftest failed in map-system-state
0046 to 004E Error on call to entry-init in reinit-iodc (error return number is 0x50)
005B to 005F The parallel card driver (RDB communications) encountered something
that it could not interpret
0066 to 006E Error on call to entry-io in console-read or console-write (error return
number is 0x50)
0080 to 0099 A trap that neither RDB or MPE/iX could interpret occurred (080n is the
hex trap number)
00A0 Bad TSTAT in write to disk for expanded taken branch
00A1 Write failure in expanded taken branch logging
00A2 Expanded taken branch logging caused lost disk I/O
00B0 A bad command was received in the MP RDB handler
00B1 The MP RDB handler semaphore was not owned by a sender
00F1 Non recoverable instruction TLB error
00F2 Non recoverable data TLB error
00F3 Non recoverable bus address error
00F4 Non recoverable bus error on I/O space read
00F5 Non recoverable bus error on memory read or write
00F6 Non recoverable bus error on I/O space write
00F7 Non recoverable bus error with processor slave
00F8 Non recoverable cache tag error
00F9 Non recoverable data cache error
00FA Non recoverable assist coprocessor error
00FB Non recoverable instruction cache error
0300 A critical HPMC occurred
0301 Bad state prevented HPMC recovery
0302 bad reserved bits prevented HPMC recovery
0303 HPMC handling corrupted the real mode stack
0321 Cache data was corrupted and cannot be located
0322 Cache data for a known address was corrupted
0340 A bus error resulted in an HPMC
0361 A coprocessor other than 0 asserted HPMC
0362 An SFU asserted HPMC
03A1 The TLB is non functional
Display Codes 4-17