Major Code Category 3 - HP 3000 9x9KS Service Manual

Major Code Category 3

Table 4-6. Processor Dependent Hardware (PDH) Codes
Ostat
TEST
TEST
TEST
TEST
TEST
INIT
INIT
INIT
INIT
INIT
INIT
INIT
WARN
WARN
WARN
WARN
WARN
WARN
FLT
FLT
FLT
FLT
FLT
FLT
FLT
FLT
FLT
FLT
FLT
FLT
FLT
FLT
4-8 Display Codes
Description
Code
Descriptions preceded by an asterisk are applicable only for the
following systems: HP 9000 K250/K260/K450/K460/Kx70, HP
VISUAL-IZE K260-EG/K460-EG/K460-XP, and HP 3000 979KS.
3x00 Start checksuming the FEPROM
3x01 Testing PDH control register
3x02 Scratch RAM under test
3xBC Test system clock setup
3xCD Checking Stable Storage validity
3x00 FEPROM checksum correct
3x01 Initialize the PDH control register
3x02 Scratch RAM successfully initialized
3x07 Entering LDB
3xBC Finished testing system clock
30C4 Clearing and revalidating EEPROM
3xCD Initializing Stable Storage
3x03 Error reading stable storage, contents are invalid
3x04 Error writing to the EEPROM
3x06 Error reading EEPROM
3x1A System Hversion in stable storage does not match the hardware
3x2A Calculation of HVERSION failed for CPU x
3xBC Skipped system clock test
3x00 FEPROM checksum failure
3x01 PDH control register failure
3x02 Fatal fault in scratch RAM
3x03 Fault reading stable storage and no console present
3x04 Fatal fault writing to the EEPROM
3x05 Write limit exceeded
3x06 Fatal fault reading EEPROM
3xCC *PDH cache size bad
3xCD Fatal error initializing Stable Storage
3x08 Invalid system board byte
3x09 Invalid system mode byte
3x0A Invalid system MFG test byte
3xBC Invalid system clock setup (CPU clock speed mismatch)
30F4 Number of boots exceeded 95,000
(Where x = Processor Memory bus slot number)