Power Monitor Card
Removal: Refer to Figure 7-6
1. Remove the front bezel.
2. Remove the Processor/Memory cover plate by loosening the four captive screws and pulling it away
from the chassis.
3. Grasp the Power Monitor card (1) and pull it out of the cabinet.
Figure 7-6 Power Monitor Card Location
Replacement:
1. Align the Power Monitor card in the appropriate slot (with the components toward the right side).
2. Insert the Power Monitor card until it contacts the system card, then press firmly.
3. Replace the Processor/Memory cover plate and tighten the four mounting screws.
Memory SIMMs
Be sure to observe all memory SIMM configuration rules. The memory SIMMs on the HP 9000/K100 are
located on the system card (inside the cabinet, rear access). The memory SIMMs on the HP 3000/939KS/
959KS/969KS and the HP 9000/K2x0/K4x0 are located on removable Memory Carrier cards. You must be
aware of the SIMM loading if two memory carriers are present.
7-8
Removal and Replacement