Mpe/Ix Remote Access - HP 3000 9x9KS Service Manual

MPE/iX Remote Access

The following procedures are only applicable if HP Predictive has not been installed. If HP predic-
tive is installed, use Predictive to configure the internal modem for remote access. Refer to the Pre-
dictive Support User's Guide (part number 50779-90018).
To have remote access for the HP 3000 computer you must configure Logical Device 21 in the operating
system and on the core I/O card.
Logical Device 21 System Configuration
To establish a dial-in session for remote access through the internal modem, logical device 21 has to be
configured in the operating system. To check the logical device 21, perform the following steps:
1. At the prompt, type
MPE/iX
2. At the prompt, type
SYSGEN>
3. AT the prompt, type
IO>
parameters for path address 10/4/0.1, as shown:
PATH:
ID:
PMGR:
LMGR:
4. If the information is incorrect, delete device 21 by typing
information.
5. If there is no information displayed for the path 10/4/0.1 (logical device 21), then add the necessary
configuration information with the
io> AD 21 ID=A2372-60003-CONSOLE-TERMINAL; PATH=10/4/0.1
6. In the I/O submenu of SYSGEN, do a list device 21 (LD 21) and ensure that the following
information is shown:
LDEV: 21 DEVNAME:
ID: A2372-60003-CONSOLE-TERMINAL
PATH: 10/4/0.1
CLASS: TERM
NOTE
.
SYSGEN
. This puts you into the I/O submenu of SYSGEN.
IO
. The
lpath 10/4/0.1 lpath (list path)
10/4/0.1
A2372-60003-CONSOLE-TERMINAL
CDM_CONSOLE_DM
TIO_TLDM
command, as shown:
AD 21
command will display the configured
LDEV:
TYPE:
PMGRPRI:
MAXIOS:
, before adding the correct
io> DD 21
OUTDEV: 21 MODE: JAID
RSIZE: 40 DEVTYPE: TERM
MPETYPE: 16 MPESUBTYPE: 0
Install and Configuration
21
TERM
9
0
2-21