Key Switch - HP 3000 9x9KS Service Manual

Replacement:
Be sure any address jumpers or switches match the settings of the device that was removed.
1. Insert the device into the peripheral bay from the front. Use the slot guides on each side of the periph-
eral bay to align the device.
2. Insert the four mounting screws.
3. Connect the SCSI cable and power cable.
4. Mount the peripheral interconnect card on the back of the peripheral bay.
5. Install the lower bay front grill, by inserting the bottom tabs on the grill into the slots in the bottom of
the bay and tighten the mounting screws.
6. Replace the peripheral bay into the chassis.

Key Switch

Removal:
1. Remove the front bezel.
2. Remove the front LCD display and key switch bracket by loosening the four (2 top and 2 bottom)
mounting screws.
3. Disconnect the LCD display cable and the key switch cable.
4. Remove the nut on the back of the key switch and pull the key switch through the mounting hole.
Replacement:
1. Insert the key switch through the mounting hole.
2. Replace the nut on the back of the key switch and tighten it.
3. Reconnect the LCD display cable and key switch cable.
4. Attach the front LCD display and key switch bracket to the chassis.
5. Replace the front bezel.
NOTE
Removal and Replacement 7-17