Fan Tray - HP 3000 9x9KS Service Manual

Fan Tray

There are two fans, one in the front and one in the back, located at the bottom, center of the cabinet.
Also note that there are no cables to disconnect on the fan tray.
Front Fan removal:
1. Remove the front bezel.
2. Remove the two mounting screws (on top of the fan tray).
3. Grasp the two protruding sheet metal tabs and pull the fan tray out of the chassis.
Front Fan Replacement:
1. Align the fan tray in the chassis slot at the bottom and push it in until it is flush with the chassis.
2. Insert the two mounting screws in the top mounting holes.
3. Replace the front bezel.
Rear Fan Removal:
1. Remove the lower back bezel by pressing down on the two top mounting tabs and tilting the top of the
bezel away from the chassis, and lifting up.
2. Remove the two mounting screws (on top of the fan tray).
3. Grasp the two protruding sheet metal tabs and pull the fan tray out of the chassis.
Rear Fan Replacement:
1. Align the fan tray in the chassis slot at the bottom and push it in until it is flush with the chassis.
2. Insert the two mounting screws in the top mounting holes.
3. Replace the lower back bezel.
7-32 Removal and Replacement