Connecting The Monitor, Keyboard, Mouse, And Power Supplies; Introduction; Connecting The Monitor, Keyboard And Mouse - HP D5970A - NetServer - LCII User Manual

9 Connecting the Monitor, Keyboard,
Mouse, and Power Supplies

Introduction

Use the procedures in this chapter to connect the peripheral devices to the
HP Netserver LP 2000r, and install or remove the power supply module.

Connecting the Monitor, Keyboard and Mouse

1. Connect the monitor, keyboard, and mouse to the HP Netserver LP 2000r
using the connections provided on the rear of the chassis. See Figure 9-1.
The two USB connectors are reserved for peripherals other than the keyboard
or mouse.
If you have a console switch box, refer to the switch box user guide for
instructions on connecting the keyboard, mouse, and monitor.
2. If a LAN cable is provided, you may connect it now or wait until you have
verified the HP Netserver's operation.
AC for PS
Bay #1
Power Supply
Bay #1
Power
Supply
LED
Power Supply
AC for
Bay #2
PS Bay #2
CAUTION
USB(2)
Mouse Parallel Serial B
Keyboard Video
Serial A/
LAN A/
Mgmt
Mgmt
Figure 9-1. Rear Panel Ports
The Keyboard and Mouse PS/2 ports cannot be used
interchangeably. Plugging the keyboard into the Mouse port
(or the mouse into the Keyboard port) produces an error
message and causes the system to stop the boot process.
PCI Slots (3)
LAN B External SCSI Port
Slot 3
Slot 2
Slot 1
87