Implementing Mpls Oam; Prerequisites For Mpls Lsp Ping And Traceroute For P2Mp - Cisco CRS Configuration Manual

Implementing MPLS OAM

This module describes Multiprotocol Label Switching (MPLS) P2MP Ping and Traceroute features. These
feature provide a means to check connectivity, isolate failure point, thus providing the MPLS Operations,
Administration, and Maintenance (OAM) solution.
For detailed information about MPLS commands and examples, see Cisco IOS XR MPLS Command Reference
for the Cisco CRS Router.
Feature History for Implementing MPLS OAM
Release
Release 4.0.0
•
•
•
•
•
•
•

Prerequisites for MPLS LSP Ping and Traceroute for P2MP

Before you use the MPLS LSP Ping and Traceroute for P2MP feature, you should have the support for
following:
• Cisco IOS XR software Release 4.0.0 or a later release
• Configure Resource Reservation Protocol (RSVP) features on the headend, midpoint, and tailend routers
Prerequisites for MPLS LSP Ping and Traceroute for P2MP, page 395
MPLS Network Management with MPLS LSP Ping and MPLS LSP Traceroute, page 396
Roles of Various Routers, page 396
P2MP Ping, page 397
P2MP Traceroute, page 398
MPLS OAM Support for BGP 3107, page 399
Configure the Ping and Traceroute: Example, page 399
in the MPLS network
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
C H A P T E R
Modification
This feature was introduced.
8
395