Cisco CRS Configuration Manual page 378

Configure the MPLS-TE Auto-Tunnel Backup: Example
Fast Reroute: Enabled, Protection Desired: Node, Bandwidth
Record-route: Enabled
Policy-class: 0 (Not configured)
Logging: None
List of Mesh Groups (count 1)
1
This example shows the details about the tunnel that is using auto-backup type of attribute-set.
RP/0/RP0/CPU0:router# show mpls traffic-eng tunnels attribute-set auto-backup ab
Name: tunnel-te3000
Status:
Admin:
path option 20,
path option 10,
G-PID: 0x0800 (derived from egress interface properties)
Bandwidth Requested: 0 kbps
Creation Time: Tue Aug 14 23:24:27 2012 (00:05:28 ago)
Config Parameters:
Bandwidth:
Number of affinity constraints: 2
Metric Type: TE (default)
Hop-limit: disabled
AutoRoute: disabled
Forwarding-Adjacency: disabled
Loadshare:
Auto-bw: disabled
Fast Reroute: Disabled, Protection Desired: None
Path Protection: Not Enabled
Soft Preemption: Disabled
Auto Backup:
Protected LSPs: 2
Protected S2L Sharing Families: 0
Protected S2L: 0
Protected i/f: PO0/3/0/1
Attribute-set: ab
Protection: NHOP
Unused removal timeout: not running
History:
Tunnel has been up for: 00:04:57 (since Tue Aug 14 23:24:58 EST 2012)
Current LSP:
Uptime: 00:04:57 (since Tue Aug 14 23:24:58 EST 2012)
Path info (OSPF 100 area 16909060):
Node hop count: 2
Hop0: 23.9.0.2
Hop1: 12.9.0.2
Hop2: 12.9.0.1
Hop3: 1.1.1.1
Displayed 1 (of 7) heads, 0 (of 3) midpoints, 0 (of 0) tails Displayed 1 up, 0 down, 0
recovering, 0 recovered heads
This example shows the protected interface for auto-backup auto-tunnels.
RP/0/RP0/CPU0:router# show mpls traffic-eng tunnels backup protected-interface
Interface: Gi0/2/0/1 (auto-tunnel backup)
SRLG: N/A, NHOP-only: No
Attribute-set: Not configured
Auto-tunnel backup recreate time remaining:
No backup tunnel found
Interface: Gi0/2/0/3
tunnel-te340
Interface: PO0/3/0/1 (auto-tunnel backup)
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
360
Destination: 1.1.1.1 (auto-tunnel backup)
up Oper: up Path:
type explicit (autob_nhop_te3000) (Basis for Setup, path weight 2)
type explicit (autob_nhop_srlg_te3000) [disabled]
0 kbps (CT0) Priority:
Include bit map : 0x4
Include name : blue
Exclude bit map : 0x2
Exclude name : red
LockDown: disabled
0 equal loadshares
PROTECTED : out i/f:
valid Signalling: connected
CT0
7 7
Policy class: 1
timer not running
PO0/3/0/2 Admin:
Implementing MPLS Traffic Engineering
up Oper: up