Configuring Destinations For The Tunnel Interface - Cisco CRS Configuration Manual

Implementing MPLS Traffic Engineering
Command or Action
Step 7
show mrib ipv6 route source-address
Example:
RP/0/RP0/CPU0:router# show mrib ipv6 route ff35::1
Related Topics
Point-to-Multipoint RSVP-TE , on page 195
Configure Point-to-Multipoint for the Source: Example, on page 363
Configure the Point-to-Multipoint Solution: Example, on page 364
Enabling Multicast Routing on the Router, on page 307

Configuring Destinations for the Tunnel Interface

Perform this task to configure three destinations for the tunnel interface for Point-to-Multipoint (P2MP).
These variations are listed to ensure that the destination and path option configurations are separate from the
tunnel interface.
• Different path option is used for different destinations. This task shows three destinations.
• Explicit path option is based on an ID or a name.
• Default path option is similar to the Point-to-Point (P2P) LSP.
Before You Begin
These prerequisites are required to configure destinations for the tunnel interface.
• Multicast routing must be enabled on both the tunnel-mte interface and customer-facing interface from
• Static-group must be configured on the tunnel-mte interface to forward specified multicast traffic over
the source.
P2MP LSP.
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
Configuring Point-to-Multipoint TE
Purpose
Verifies the multicast static mapping.
311