Implementing MPLS Traffic Engineering
Command or Action
Related Topics
Auto-Tunnel Mesh, on page 206
Destination List (Prefix-List), on page 207
Enabling Stateful PCE Client
Perform these steps to enable stateful PCE client.
SUMMARY STEPS
1. configure
2. mpls traffic-eng
3. pce
4. stateful-client
5. capabilities { instantiation | update}
6. Use the commit or end command.
DETAILED STEPS
Command or Action
Step 1
configure
Example:
RP/0/RP0/CPU0:router# configure
Step 2
mpls traffic-eng
Example:
RP/0/RP0/CPU0:router(config)#mpls traffic-eng
Step 3
pce
Example:
RP/0/RP0/CPU0:router(config-mpls-te)#pce
Step 4
stateful-client
Purpose
• Cancel—Remains in the configuration session, without
committing the configuration changes.
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
Enabling Stateful PCE Client
Purpose
Enters global configuration mode.
Enters MPLS TE configuration mode.
Enters PCE configuration mode.
Enters stateful PCE client configuration mode.
331