Configuring Path-Selection Cost Limit Per Te Tunnel - Cisco CRS Configuration Manual

Implementing MPLS Traffic Engineering
DETAILED STEPS
Command or Action
Step 1
configure
Example:
RP/0/RP0/CPU0:router# configure
Step 2 mpls traffic-eng
Example:
RP/0/RP0/CPU0:router(config)# mpls
traffic-eng
Step 3
path-selection cost-limit cost-limit
Example:
RP/0/RP0/CPU0:router(config-mpls-te)#
path-selection cost-limit 3
Step 4 Use the commit or end command.

Configuring Path-selection Cost Limit per TE Tunnel

Perform these steps to configure path-selection cost limit per MPLS TE tunnel:
SUMMARY STEPS
1. configure
2. interface tunnel-te tunnel-id
3. path-selection cost-limit cost-limit
4. Use the commit or end command.
Purpose
Enters global configuration mode.
Enters MPLS-TE configuration mode.
Sets the upper limit on the path aggregate admin-weight when
computing paths for MPLS TE LSPs.
commit—Saves the configuration changes and remains within the
configuration session.
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the configuration
session.
• No—Exits the configuration session without committing the
configuration changes.
• Cancel—Remains in the configuration session, without
committing the configuration changes.
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
Configuring Path-selection Cost Limit
337