Configuring the Shared Risk Link Groups
Command or Action
Step 8
Use the commit or end command.
Step 9
show mpls traffic-eng tunnels [auto-bw]
Example:
RP/0/RP0/CPU0:router# show mpls traffic-eng
tunnels auto-bw
Related Topics
MPLS-TE Automatic Bandwidth Overview, on page 190
Configure Automatic Bandwidth: Example, on page 353
Configuring the Shared Risk Link Groups
To activate the MPLS traffic engineering SRLG feature, you must configure the SRLG value of each link that
has a shared risk with another link.
Configuring the SRLG Values of Each Link that has a Shared Risk with Another Link
Perform this task to configure the SRLG value for each link that has a shared risk with another link.
Note
You can configure up to 30 SRLGs per interface.
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
294
Purpose
commit—Saves the configuration changes and remains within the
configuration session.
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the configuration
session.
• No—Exits the configuration session without committing the
configuration changes.
• Cancel—Remains in the configuration session, without
committing the configuration changes.
Displays the MPLS-TE tunnel information only for tunnels in which
the automatic bandwidth is enabled.
Implementing MPLS Traffic Engineering