Cisco CRS Configuration Manual page 326

Configuring Point-to-Multipoint TE
Command or Action
Step 3
address-family {ipv4 | ipv6 }
Example:
RP/0/RP0/CPU0:router(config-mcast)# address-family
ipv6
RP/0/RP0/CPU0:router(config-mcast-default-ipv6)#
Step 4 interface tunnel-mte tunnel-id
Example:
RP/0/RP0/CPU0:router(config-mcast-default-ipv6)#
interface tunnel-mte 1
RP/0/RP0/CPU0:router(config-mcast-default-ipv6-if)#
Step 5 enable
Example:
RP/0/RP0/CPU0:router(config-mcast-default-ipv6-if)#
enable
Step 6
exit
Example:
RP/0/RP0/CPU0:router(config-mcast-default-ipv6-if)#
exit
RP/0/RP0/CPU0:router(config-mcast-default-ipv6)#
Step 7 interface type interface-path-id
Example:
RP/0/RP0/CPU0:router(config-mcast-default-ipv6)#
interface GigabitEthernet0/2/0/3
RP/0/RP0/CPU0:router(config-mcast-default-ipv6-if)#
Step 8 enable
Example:
RP/0/RP0/CPU0:router(config-mcast-default-ipv6-if)#
enable
Step 9
Use the commit or end command.
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
308
Implementing MPLS Traffic Engineering
Purpose
Configures the available IPv4 or IPv6 address prefixes
to enable multicast routing and forwarding on all router
interfaces.
Configures an MPLS-TE P2MP tunnel interface.
Enables multicast routing on the tunnel-mte interface.
Exits the current configuration mode.
Configures multicast routing on the GigabitEthernet
interface.
Enables multicast routing on the GigabitEthernet
interface.
commit—Saves the configuration changes and remains
within the configuration session.
end—Prompts user to take one of these actions: