Disabling Ldp Auto-Configuration - Cisco CRS Configuration Manual

Disabling LDP Auto-Configuration

Command or Action
Step 5
interface type interface-path-id
Example:
RP/0/RP0/CPU0:router(config-ospf-ar)#
interface pos 0/6/0/0
RP/0/RP0/CPU0:router(config-ospf-ar-if)
Step 6 Use the commit or end command.
Related Topics
IGP Auto-configuration, on page 18
Configuring LDP Auto-Configuration: Example, on page 84
Disabling LDP Auto-Configuration, on page 62
Disabling LDP Auto-Configuration
Perform this task to disable IGP auto-configuration.
You can disable auto-configuration on a per-interface basis. This lets LDP enable all IGP interfaces except
those that are explicitly disabled.
SUMMARY STEPS
1. configure
2. mpls ldp
3. interface type interface-path-id
4. igp auto-config disable
5. Use the commit or end command.
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
62
Implementing MPLS Label Distribution Protocol
Purpose
Enables LDP auto-configuration on the specified interface. The
LDP configurable limit for maximum number of interfaces does
not apply to IGP auto-config interfaces.
commit—Saves the configuration changes and remains within the
configuration session.
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the
configuration session.
• No—Exits the configuration session without committing the
configuration changes.
• Cancel—Remains in the configuration session, without
committing the configuration changes.