Configuring Policy-Based Tunnel Selection - Cisco CRS Configuration Manual

Configuring Policy-based Tunnel Selection

Command or Action
Step 11
show mpls traffic-eng pce peer [address | all]
Example:
RP/0/RP0/CPU0:router# show mpls traffic-eng
pce peer
Step 12
show mpls traffic-eng pce tunnels
Example:
RP/0/RP0/CPU0:router# show mpls traffic-eng
pce tunnels
Related Topics
Path Computation Element, on page 185
Configure PCE: Example, on page 351
Configuring Policy-based Tunnel Selection
Perform this task to configure policy-based tunnel selection (PBTS).
SUMMARY STEPS
1. configure
2. interface tunnel-te tunnel-id
3. ipv4 unnumbered type interface-path-id
4. signalled-bandwidth {bandwidth [class-type ct] | sub-pool bandwidth}
5. autoroute announce
6. destination ip-address
7. policy-class {1 - 7} | {default}
8. path-option preference-priority {explicit name explicit-path-name}
9. Use the commit or end command.
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
286
Implementing MPLS Traffic Engineering
Purpose
Displays the PCE peer address and state.
Displays the status of the PCE tunnels.