Configuring Mpls -Te And Fast-Reroute On Ospf - Cisco CRS Configuration Manual

Configuring MPLS -TE and Fast-Reroute on OSPF

Command or Action
Step 10
interface tunnel-te tunnel-id
Example:
RP/0/RP0/CPU0:router(config)# interface tunnel-te
4
RP/0/RP0/CPU0:router(config-if)#
Step 11 signalled-bandwidth {bandwidth [class-type ct] |
sub-pool bandwidth}
Example:
RP/0/RP0/CPU0:router(config-rsvp-if)#
signalled-bandwidth 10 class-type 1
Step 12 Use the commit or end command.
Related Topics
Configuring Traffic Engineering Tunnel Bandwidth, on page 123
Maximum Allocation Bandwidth Constraint Model, on page 173
Configuring MPLS -TE and Fast-Reroute on OSPF
Perform this task to configure MPLS-TE and Fast Reroute (FRR) on OSPF.
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
238
Implementing MPLS Traffic Engineering
Purpose
Configures an MPLS-TE tunnel interface.
Configures the bandwidth required for an MPLS TE tunnel.
Because the default tunnel priority is 7, tunnels use the
default TE class map (namely, class-type 1, priority 7).
commit—Saves the configuration changes and remains
within the configuration session.
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the
configuration session.
• No—Exits the configuration session without
committing the configuration changes.
• Cancel—Remains in the configuration session,
without committing the configuration changes.