Configuring The Window Size For An Interface For Rsvp Authentication - Cisco CRS Configuration Manual

Configuring an Interface for RSVP Authentication
Command or Action
Related Topics
RSVP Authentication Design, on page 118
RSVP Authentication by Using All the Modes: Example, on page 152

Configuring the Window Size for an Interface for RSVP Authentication

Perform this task to configure the window size for an interface for RSVP authentication to check the validity
of the sequence number received.
SUMMARY STEPS
1. configure
2. rsvp interface type interface-path-d
3. authentication
4. window-size N
5. Use the commit or end command.
DETAILED STEPS
Command or Action
Step 1 configure
Example:
RP/0/RP0/CPU0:router# configure
Step 2
rsvp interface type interface-path-d
Example:
RP/0/RP0/CPU0:router(config)# rsvp
interface POS 0/2/1/0
RP/0/RP0/CPU0:router(config-rsvp-if)#
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
140
Implementing RSVP for MPLS-TE and MPLS O-UNI
Purpose
• Yes— Saves configuration changes and exits the configuration
session.
• No—Exits the configuration session without committing the
configuration changes.
• Cancel—Remains in the configuration session, without
committing the configuration changes.
Purpose
Enters global configuration mode.
Enters RSVP interface configuration mode.