Cisco CRS Configuration Manual page 274

Configuring GMPLS
Command or Action
remote switching-capability lsc
Step 6 remote interface-id unnum value
Example:
RP/0/RP0/CPU0:router(config-mpls-te-if-adj)#
remote interface-id unnum 7
Step 7
remote node-id node-id
Example:
RP/0/RP0/CPU0:router(config-mpls-te-if-adj)#
remote node-id 10.10.10.10
Step 8 neighbor name
Example:
RP/0/RP0/CPU0:router(config-mpls-te-if-adj)#
neighbor OXC1
Step 9 remote node-id address
Example:
RP/0/RP0/CPU0:router(config-mpls-te-if-adj)#
remote node-id 10.10.10.10
Step 10 Use the commit or end command.
Step 11 show mpls lmp
Example:
RP/0/RP0/CPU0:router# show mpls lmp
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
256
Implementing MPLS Traffic Engineering
Purpose
Configures the unnumbered interface identifier. Identifiers,
which you specify by using this command, are the values
assigned by the neighbor at the remote side.
Configures the remote node ID.
Configures or updates an LMP neighbor and its associated
parameters.
Configures the remote node ID.
commit—Saves the configuration changes and remains
within the configuration session.
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the
configuration session.
• No—Exits the configuration session without
committing the configuration changes.
• Cancel—Remains in the configuration session, without
committing the configuration changes.
Verifies the assigned value for the local interface identifiers.