Cisco CRS Configuration Manual page 404

Configuring LMP for GMPLS UNI
Command or Action
Step 2
lmp
Example:
RP/0/RP0/CPU0:router(config)# lmp
Step 3
gmpls optical-uni
Example:
RP/0/RP0/CPU0:router(config-lmp)# gmpls optical-uni
Step 4 neighbor name
Example:
RP/0/RP0/CPU0:router(config-lmp-gmpls-uni)# neighbor
nbr1
Step 5 ipcc routed
Example:
RP/0/RP0/CPU0:router(config-lmp-gmpls-uni-nbr-nbr1)#
ipcc routed
Step 6 router-id ipv4 unicast address
Example:
RP/0/RP0/CPU0:router(config-lmp-gmpls-uni-nbr-nbr1)#
router-id ipv4 unicast 10.10.4.4
Step 7 Use the commit or end command.
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
386
Purpose
Enters LMP configuration mode.
Enters GMPLS UNI configuration submode.
Specifies an LMP neighbor for GMPLS and enters LMP
GMPLS UNI neighbor configuration submode.
Specifies the LMP neighbor IPCC configuration for
GMPLS UNI.
Configures the LMP unicast router ID for GMPLS.
commit—Saves the configuration changes and remains
within the configuration session.
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the
configuration session.
• No—Exits the configuration session without
committing the configuration changes.
• Cancel—Remains in the configuration session,
without committing the configuration changes.
Implementing GMPLS UNI