Disabling Lmp Message Exchange - Cisco CRS Configuration Manual

Implementing MPLS Traffic Engineering
Command or Action

Disabling LMP Message Exchange

Perform the following task to disable LMP message exchange. LMP is enabled by default. You can disable
LMP on a per neighbor basis using the lmp static command in LMP protocol neighbor mode.
LMP is recommended unless the peer optical device does not support LMP (in which case it is necessary
Note
to disable it at both ends).
SUMMARY STEPS
1. configure
2. mpls traffic-eng
3. lmp neighbor name
4. lmp static
5. ipcc routed
6. remote node-id node-id
7. Use the commit or end command.
DETAILED STEPS
Command or Action
Step 1 configure
Example:
RP/0/RP0/CPU0:router# configure
Step 2
mpls traffic-eng
Example:
RP/0/RP0/CPU0:router(config)# mpls traffic-eng
Purpose
• Yes— Saves configuration changes and exits the
configuration session.
• No—Exits the configuration session without committing
the configuration changes.
• Cancel—Remains in the configuration session, without
committing the configuration changes.
Purpose
Enters global configuration mode.
Enters MPLS-TE configuration mode.
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
Configuring GMPLS
253