Cisco CRS Configuration Manual page 90

Enabling MLDP
DETAILED STEPS
Command or Action
Step 1
configure
Example:
RP/0/RP0/CPU0:router# configure
Step 2
mpls ldp
Example:
RP/0/RP0/CPU0:router(config)# mpls ldp
Step 3 mldp
Example:
RP/0/RP0/CPU0:router(config-ldp)# mldp
Step 4
address-family ipv4
Example:
RP/0/RP0/CPU0:router(config-ldp-mldp)#
address-family ipv4
Step 5 mofrr
Example:
RP/0/RP0/CPU0:router(config-ldp-mldp-af)#
mofrr
Step 6 end or commit
Example:
RP/0/RP/0/RP0/CPU0:router
(config-ldp-mldp-af)# end
or
RP/0/RP/0/RP0/CPU0:router
(config-ldp-mldp-af)# commit
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
72
Implementing MPLS Label Distribution Protocol
Purpose
Enters Global Configuration mode.
Enters MPLS LDP configuration mode.
Enables MLDP.
Enables MLDP for IPv4 address family.
Enables MoFRR support.
• When you issue the end command, the system prompts you
to commit changes:
Uncommitted changes found, commit them before
exiting(yes/no/cancel)?
[cancel]:
• Entering yes saves configuration changes to the running
configuration file, exits the configuration session, and returns
the router to EXEC mode.
• Entering no exits the configuration session and returns the
router to EXEC mode without committing the configuration
changes.