Configuring Unequal Load Balancing
DETAILED STEPS
Command or Action
Step 1
configure
Example:
RP/0/RP0/CPU0:router# configure
Step 2
mpls traffic-eng
Example:
RP/0/RP0/CPU0:router(config)# mpls
traffic-eng
Step 3
load-share unequal
Example:
RP/0/RP0/CPU0:router(config-mpls-te)#
load-share unequal
Step 4
Use the commit or end command.
Step 5
show mpls traffic-eng tunnels
Example:
RP/0/RP0/CPU0:router# show mpls
traffic-eng tunnels
Related Topics
Unequal Load Balancing, on page 184
Configure Unequal Load Balancing: Example, on page 350
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
280
Purpose
Enters global configuration mode.
Enters the MPLS-TE configuration mode.
Enables unequal load sharing across TE tunnels to the same
destination.
commit—Saves the configuration changes and remains within the
configuration session.
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the configuration
session.
• No—Exits the configuration session without committing the
configuration changes.
• Cancel—Remains in the configuration session, without
committing the configuration changes.
Verifies the state of unequal load balancing, including bandwidth
and load-share values.
Implementing MPLS Traffic Engineering